How we clean solar panels in California
Cleaning solar panels well is mostly about being gentle and patient. Four habits shape every visit we make, whether the panels sit on a tile roof, a carport or a rack in the backyard.
1 of 4
Water that dries clear
Tap water in the pass is fine to drink but full of dissolved minerals. When it dries on glass in the sun, it leaves a ring of white spots. That is why we pass every drop through a purifying filter before it reaches the brush. The water that comes out is deionized, with almost nothing left in it to dry into a mark.
Purified water also does a lot of the cleaning on its own. It lifts dust and pollen readily, which means less brushing and almost never any soap. When a spot does need help, such as a stubborn dropping, we use a small amount of a mild, gentle cleaner and rinse it away completely.
- Purified, deionized waterDries clear without wiping or squeegees on the glass.
- Low flow rinseEnough to carry the dust away, gentle on roofs and yards.
- No harsh chemicalsPlain water first, a mild cleaner only for a stubborn spot.

2 of 4
Soft brushes, never a pressure washer
Solar glass has a thin coating that helps it shed light and water. Hard bristles, scouring pads and strong water jets can wear that surface over time, so we never pressure-wash panels and we never scrub them dry. Our brush heads are soft, made for glass, and always wet while they move.
Most of the time the brush sits on the end of a water-fed pole. The pole is light, extends far enough for most single story roofs, and lets us work from the ground. Water flows through the bristles as they pass, so dust is floated off rather than dragged across the surface.
- Soft, non-abrasive bristlesKept wet the whole time they touch the glass.
- Water-fed poleLets us reach most roofs from the ground.
- Never pressure-washedStrong jets are kept far away from panels.

3 of 4
Cool mornings, calm glass
By early afternoon in summer, panels in the pass can be too hot to touch. Pouring cool water on hot glass is not a good idea, and water also dries too fast to rinse cleanly. So we start early. Our weekday visits begin at 7:00 AM, and most cleanings are finished before the heat of the day.
Mornings are often calmer too. The wind through the pass usually picks up in the afternoon, and a breeze can blow fresh dust onto wet glass. Starting early gives the panels a clean rinse and time to dry before the wind returns.
- Starts at 7:00 AMWeekdays and Saturday mornings.
- Cool glass, cool waterNo cold rinse on panels baked by the sun.
- Before the windPanels dry clean before afternoon gusts.

4 of 4
Safe access to the roof
Most jobs never need anyone on the roof. When they do, we use an extension ladder with a wide stabilizer that rests on the roof, not the gutter, and anyone above the ground wears a harness tied to a secure point. Tile roofs get extra care: we step only where the tiles can take weight, or we stay off them entirely and reach with the pole.
We keep the work area simple and tidy. Hoses run along walls instead of across paths, poles are never left lying in the yard, and children and pets are asked to stay inside while we work. If we see something unusual during the visit, such as a cracked panel or loose debris on the roof, we let you know and leave it as it is.
- Ladder with a stabilizerRests on the roof surface, away from the gutter.
- Harness when on the roofTied to a secure point every time.
- Tile-aware stepsOr no steps at all when the pole can reach.

What you get afterwards
When we finish, we send a short message by your chosen method: the visit is done, the panels have been washed and rinsed, and anything unusual we noticed is listed in plain words. Clean glass simply lets more sunlight reach the cells, and the panels look the way they did on the first day.
If your panels needed more than one pass in places, we mention it, along with a suggestion for how soon the next cleaning might be useful. That way you can decide whether a seasonal schedule makes sense for your home.
Questions about our method
Do you use a pressure washer?
Never on panels. Strong jets can harm the glass surface and push water where it should not go.
Do you use soap?
Rarely. Purified water lifts most dust and pollen. A mild, gentle cleaner is used only on a spot that will not come off with water.
Do I need to be home?
Not if we can reach the hose bib and the yard. We contact you before we arrive and after we finish.
Do I need to switch anything off?
No. We wash the outside of the glass and frames with purified water, and the rest of your home carries on as usual.
Can I clean my own panels?
We do not recommend climbing onto a roof yourself. If you rinse panels from the ground, use plain water, a soft brush and a cool morning.
Want this for your panels?
Send the number of panels, the stories and the roof type. We reply by your chosen method and agree on a cool morning for the visit.