Rooftop solar panel cleaning in California

The panels on your roof sit in the wind every day. We wash them with purified water and soft brushes, early in the morning, and leave the glass clear, without water spots.

Water-fed pole with a soft brush moving over dusty solar panels on a gray shingle roof, half of the glass already rinsed

Most homes in the pass carry their panels on a tile or shingle roof that faces south or west, right where the afternoon wind drops its dust. A thin tan film builds up within weeks, rain is rare for much of the year, and when it does come it often leaves dried streaks along the lower frame instead of rinsing anything away.

Our rooftop visit is a plain, careful wash. Water passes through a purifying filter so it dries without spots, a soft brush on a long water-fed pole loosens the film, and a gentle rinse carries it off the glass. On most single story homes the whole job happens from the ground. When a roof is too tall or too steep for the pole alone, we set a stabilized ladder and work with a harness.

What the visit includes

  • A walk around the house to plan where the pole and hose go
  • Purified, deionized water for a rinse that dries clear
  • Soft, non-abrasive brush heads made for glass
  • Frames and the lower edge rinsed, where grit collects
  • Leaves and loose bits lifted from around the array by hand
  • A short note afterwards if we noticed anything unusual

How it goes

  1. Before we start

    We look at the roof from the ground, find the hose bib, and check where water will run off so it stays away from doors, cars and patio furniture.

  2. Loosen

    The brush moves across each panel in slow overlapping passes while purified water flows through the bristles. No soap goes on the glass unless a spot truly needs it.

  3. Rinse

    A low flow rinse sheets from the top row down, so the dust leaves the array instead of settling on the panels below.

  4. Look again

    We step back, check the glass in the morning light, go over any spot that needs a second pass, and coil everything up.

Tile, shingle and the wind in the pass

Clay tile roofs are lovely and fragile. We avoid walking on tile whenever the pole can reach, and when someone has to go up, they step only where the roof can take weight. Composition shingle is easier underfoot, but on hot afternoons it softens, which is one more reason we keep to cool morning hours.

The pass funnels wind most afternoons, so dust returns faster here than in calmer valleys. That does not mean you need a visit every month. For many homes two or three washes a year keep the glass in good shape, and our seasonal schedule can plan them for you.

Before we arrive

  • Leave the side gate unlocked on the visit day
  • Move cars away from the drip line under the panels
  • Bring pets inside while we work
  • Tell us about any sprinklers set to run that morning

Questions about rooftop panel cleaning

Do you need to get on my roof?

Usually not. Most single story roofs are reached from the ground with a water-fed pole. For taller or steeper roofs we use a ladder with a stabilizer and a harness, and we tell you beforehand.

Why purified water instead of tap water?

Tap water in the area carries minerals that dry into white spots. Purified water has almost nothing left in it, so the glass dries clear without wiping.

Do you use soap?

Plain purified water handles most dust and pollen. For a sticky spot, such as bird droppings, we may use a small amount of mild, gentle cleaner and rinse it well.

Can you clean in the afternoon?

We prefer mornings. Cool glass and cool water are kinder to the panels, and the wind is usually calmer before noon.

How long does a visit take?

It depends on the number of panels and how easy the roof is to reach. When you send the panel count and number of stories, we give you a time window for the visit.

Ready for clear glass?

Send the number of panels, the stories and the roof type. We reply by your chosen method and agree on a cool morning for the visit.